Normal Mode

Be sure to follow the steps on the Start Here page prior to starting.

After completing the Start Here, fill out the form below and click "Submit" to receive a secure Cisco router configuration file.

About Your Router

Enter a few details about your router:

Code version:

(

)

Router model:

Crypto support?:

Yes No

Router IP Information

Information relating to your router's interface names and IP addresses.

Gateway

This IP Address should be provided by your Internet Service Provider (ISP).

Gateway IP Address:

Outside (WAN) Interface

The Outside or Wide Area Nework (WAN) Interface is the one that connects your router to the Internet Service Provider's (ISP's) network.

Outside (WAN) Inteface Name:

IP Address:

Subnet Mask:

Inside Interface

The Inside Interface is the one that connects the router to your Firewall or inside network.

Inside Interface Name:

IP Address:

Subnet Mask:

Service IP's and Information

IP addresses for services and configuring access to the router.

Loopback Interface

Enter an IP address for your loopback interface (if you don't know, enter 127.0.0.1).

Loopback IP:

NTP Servers

Enter the IP addresses for your Network Time Protocol (NTP) Servers. (If you don't know, find one here.)

NTP Server 1:

NTP Server 2:

Remote Access

Enter the IP address of a trusted computer you will use to access the router remotely.

Trusted IP:

User Information

Enter a user name and password (change the user name, password, and enable secret password in the text file you receive prior to loading into the router).

User name:

Password:

Enable Secret Password:

Logging

Provide some information to set up logging.

Configure Syslog to use a port on this router

Interface name and IP address.

Local DMZ Interface Name:

Local DMZ Interface IP:

Syslog server IP address and DMZ subnet mask.

Local DMZ Syslog Server IP:

Local DMZ Interface Mask:

Configure Syslog to use a DMZ on the Firewall

Firewall DMZ Syslog Server IP address:

Configure local logging only